1990 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Curb Idle Speed Check

  1. Ensure engine is at operating temperature and all accessories are off. Place transmission in Neutral and front wheels are in a straight-ahead position.
  2. Check ignition timing and adjust if necessary. Run engine at 2000-3000 RPM for more than 5 seconds. Allow engine to idle for 2 minutes. Check idle speed. Refer to IDLE SPEED SPECIFICATIONSΒ  . If idle speed is not within specification, diagnosis of Idle Speed Control (ISC) motor is necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.