1990 Eagle Summit Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Circuit Tests

During testing, diagnostic procedure(s) may also be referred to as a numbered chart. When performing circuit test, refer to WIRING DIAGRAMΒ  .

AUTOMATIC SEAT BELT CIRCUIT TESTING

Diagnostic Procedure Circuit Test (1) Figure
Chart No. 1 Control Unit Power Supply & Ground Circuit Fig 1
Chart No. 2 Buzzer Circuit Fig 2
Chart No. 2 Key Reminder Switch Circuit Fig 3
Chart No. 2 Seat Belt Warning Light Circuit Fig 4
Chart No. 3 Motor Supply & Drive Circuits Fig 5
Chart No. 4 Buckle Switch Circuit Fig 6
Chart No. 4 Outer Switch Circuit Fig 7
Chart No. 4 Release Switch Circuit (Driver's Side) Fig 8
Chart No. 5 Fasten Switch Circuit (Driver's Side) Fig 9
Chart No. 5 Latch Switch Circuit (Driver's Side) Fig 9
Chart No. 5 Fasten Switch Circuit (Passenger's Side) Fig 10
Chart No. 5 Latch Switch Circuit (Passenger's Side) Fig 10
Chart No. 5 Release Switch Circuit (Passenger's Side) Fig 10
(1) Each figure contains the diagnostic procedure for the circuit indicated.
Fig 1: Diagnostic Procedure (Chart No. 1) Control Unit Power Supply & Ground Circuit
G00168254Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.