Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Eagle Summit Base, AutomaticFACTORY OEM SERVICE PROCEDURE
High Altitude Vehicles
- Disconnect vacuum advance hose at outer diaphragm of distributor (White stripe on hose). Check basic ignition timing. If basic ignition timing is not within specification, loosen distributor and rotate to adjust timing as necessary. See IGNITION TIMING SPECIFICATIONSΒ .
- Reconnect vacuum hose at distributor. If vehicle is at an elevation of more than 3900 ft. (1190 m) when ignition timing is checked, high altitude compensation system should apply vacuum to outer diaphragm of distributor, causing ignition timing to advance to 12 degrees at idle. This is actual ignition timing.
IGNITION TIMING SPECIFICATIONS (Degrees BTDC @ RPM)
| Application | (1) Basic | (1)(2) Actual | |||||
|---|---|---|---|---|---|---|---|
| 1.5L | |||||||
| Colt, Colt 200, Summit | 5 @ 650-850 | 10 @ 650-850 | |||||
| Colt Wagon | 5 @ 600-800 | 15 @ 600-800 | |||||
| 1.6L Colt, Colt 200, Summit | 5 @ 650-850 | 8 @ 650-850 | |||||
| 1.8L Colt Wagon | 5 @ 600-800 | 15 @ 600-800 | |||||
| 2.0L SOHC Colt Vista | 5 @ 650-850 | 10 @ 650-850 | |||||
| 2.4L Ram-50 | 5 @ 650-850 | 8 @ 650-850 | |||||
| 3.0L Ram-50 | 8 @ 600-800 | 15 @ 600-800 | |||||
|
|||||||
| Application | Wire Color | Location | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| Colt, Colt Vista, | |||||||||||
| Colt 200 & Summit | |||||||||||
| 1.5L, 1.6L & 2.0L | Yellow/Red | (3) * | |||||||||
| Colt Wagon 1.5L & 1.8L | Brown | (3) * | |||||||||
| Ram-50 | |||||||||||
| 2.4L | Black/Blue | (4) * | |||||||||
| 3.0L | White/Yellow | (4) * | |||||||||
|
|||||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
