1990 Eagle Summit Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES LOCATION

Component Location
A/C Dual Pressure Switch On top of receiver-drier. See Figure .
A/C Pressure Switch (1.6L) On high pressure line, near radiator. See Figure .
Back-Up Light Switch Right front of transaxle case.
Coolant Temp. Switch (1.5L A/T) Behind thermostat housing. See Figure .
Idle Position Switch (1.6L) On throttle body, above lever. See Figure .
Idle Switch (1.5L) On throttle body, below motor position sensor. See Figure .
Inhibitor Switch (A/T) Right front of transaxle, below battery.
Key Reminder Switch On ignition switch, in steering column.
Parking Brake Switch At base of parking brake lever.
Power Steering Pressure Switch On power steering pump.
Seat Belt Switch In driver's seat belt buckle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.