Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Eagle Summit Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Motors
MOTORS LOCATION
| Component | Location | |
|---|---|---|
| Automatic Seatbelt Motor | In door post, near floor. | |
| Electric Fuel Pump | In fuel tank. | |
| Heater Blower Motor | Under right side of dash. See Figure . | |
| Idle Speed Control Motor | On throttle body. See Figure . | |
| Wiper Motor | ||
| Front | On right rear corner of engine bay. | |
| Rear (Hatchback) | In liftgate. | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
