Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Eagle Premier ESFACTORY OEM SERVICE PROCEDURE
Alignment Specifications: Front
WHEEL ALIGNMENT SPECIFICATIONS (FRONT)
| Application | Specification | |||||
|---|---|---|---|---|---|---|
| Camber in Degrees (1) | ||||||
| Fraction | 21/64 +/- 1/4 | |||||
| Decimal | .33 +/- .25 | |||||
| Caster in Degrees (2) | ||||||
| Fraction | 2 5/64 +/- 3/4 | |||||
| Decimal | 2.07 +/- .75 | |||||
| Toe-In in Inches | ||||||
| Fraction | 1/16 +/- 1/16 | |||||
| Decimal | .063 +/-.063 | |||||
| Toe-In in Degrees | ||||||
| Fraction | 1/8 +/- 1/8 | |||||
| Decimal | .125 +/- .125 | |||||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
