2021 Dodge and Ram ProMaster 1500FACTORY OEM SERVICE PROCEDURE

Coil, Ignition: Installation: Left

GC0144207Courtesy of CHRYSLER GROUP, LLC
  1. Using compressed air, blow out any dirt or contaminants from around the top of spark plug.
  2. Check the condition of the ignition coil rubber boot (1). Inspect the opening of the boot (2) for any debris, tears or rips. Carefully remove any debris with a lint free cloth.
    GC0144896Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Do not apply a silicone based grease such as Mopar® Dielectric Grease to the ignition coil rubber boot. The silicone based grease will absorb into the boot causing it to stick and tear.

  3. Place a small, 360° bead of Uniflor 8172  lubricant (1) along the inside opening of the coil boot approximately 1 to 2 mm from the chamfer edge but not on the chamfered surface.
    GC0144206Courtesy of CHRYSLER GROUP, LLC
  4. Position the ignition coil (2) into the cylinder head cover opening. Using a twisting action, push the ignition coil onto the spark plug.
  5. Install the ignition coil mounting bolt (3) and tighten to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
  6. Connect and lock the electrical connector (1) to the ignition coil (2).
  7. Install the insulator and the upper intake manifold. Refer to MANIFOLD, INTAKE, INSTALLATION .
  8. Connect the negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.