Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Dodge and Ram ProMaster City BaseFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | NEW FASTENER* |
|---|---|---|---|---|
| Camshaft Position Sensor Stud Bolt | 9 | - | 80 | |
| Camshaft Position Sensor Heatshield Nut | 5 | - | 44 | |
| Spark Plugs - 2.4L | 27 | 20 | - | |
| Knock Sensor | 28 | 21 | - | |
| Ignition Coil Bolt | 8 | - | 71 | |
| Ignition Capacitor Stud Bolt | 9 | - | 80 | |
| Ignition Capacitor Heatshield Nut | 5 | - | 44 | |
| Power Distribution Center Cover Screws | 3 | - | 27 | |
| *NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. | ||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
