Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Dodge and Ram ProMaster 1500FACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| TORQUE SPECIFICATIONS | ||||
|---|---|---|---|---|
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
| Seat Belt Turning Loop Height Adjuster Mounting Screws | 20 | 15 | - | - |
| Seat Belt Turning Loop To Height Adjuster Nut | 40 | 30 | - | - |
| Seat Belt Lower Anchor To B-Pillar Screw | 40 | 30 | - | - |
| Passenger Airbag Mounting Screws | 8 | - | 71 | - |
| Seat Airbag Mounting Nuts | 5 | - | 44 | - |
| Side Curtain Airbag Mounting Screws | 8 | - | 71 | - |
| Side Curtain Airbag A-Pillar Reinforcement Mounting Screws | 9 | - | 80 | - |
| Seat Belt Buckle Mounting Screw | 40 | 30 | - | - |
| Seat Belt Lower Anchor To Bench Seat Riser Frame Bracket Screw | 40 | 30 | - | - |
| Clockspring Tension Clamp Screw | 5 | - | 44 | - |
| Occupant Restraint Controller Mounting Nuts | 8 | - | 71 | - |
| Seat Belt Turning Loop To Height Adjuster Nut | 40 | 30 | - | - |
| Seat Belt Turning Loop To Bench Seat Back Frame Mounting Screw | 40 | 30 | - | - |
| Seat Belt Retractor To Bench Seat Riser Frame Bracket Mounting Screw | 40 | 30 | - | - |
| Seat Belt Retractor To B-Pillar Mounting Screw | 40 | 30 | - | - |
| Front Impact Sensor Mounting Nut | 8 | - | 71 | - |
| Side Impact Sensor (B-Pillar) Mounting Nut | 8 | - | 71 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.