2017 Dodge and Ram Viper BaseFACTORY OEM SERVICE PROCEDURE

Sensor, Coolant Temperature: Installation

GC0135237Courtesy of CHRYSLER GROUP, LLC
1 - ENGINE COOLANT TEMPERATURE (ECT) SENSOR
2 - COOLING SYSTEM BLEED SCREW
3 - CAMSHAFT POSITION SENSOR
  1. Install the engine coolant temperature sensor. Tighten to 20 N.m (15 ft. lbs.).
  2. Connect the electrical connector to sensor.
  3. Fill the cooling system. Refer to FILLING COOLING SYSTEMΒ  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.