2017 Dodge and Ram Viper BaseFACTORY OEM SERVICE PROCEDURE

Radiator, Engine Cooling: Removal

GC0154683Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the battery negative cable (4).
  2. Drain the cooling system. Refer to DRAINING COOLING SYSTEM  .
    GC0156787Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the throttle body air inlet hose, remove the air cleaner housing assembly (1). Refer to BODY, AIR CLEANER, REMOVAL .
    NOTE:

    Oil cooler shown with out the oil lines for clarity.

    GC0156487Courtesy of CHRYSLER GROUP, LLC
  4. Remove the oil cooler (2) from the mounting bracket. Do Not  disconnect oil cooler lines. Reposition oil cooler.
    GC0156673Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the upper radiator hose (2).
    GC0156656Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the lower radiator hose (1).
    GC0135231Courtesy of CHRYSLER GROUP, LLC
  7. Remove the cooling fan assembly (4). Refer to FAN, COOLING, ELECTRIC, REMOVAL .
    GC0156484Courtesy of CHRYSLER GROUP, LLC
  8. Remove the radiator mounting bolts (1).
  9. Remove the A/C condenser mounting bolts (2).
  10. Remove the radiator from the engine compartment.Care should be taken not to damage radiator cooling fins during removal. 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.