Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Dodge and Ram Viper BaseFACTORY OEM SERVICE PROCEDURE
Module, Occupant Classification (OCM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B0061-13 | PASSENGER SEATBELT TENSION SENSOR-CIRCUIT OPEN |
| B0061-16 | PASSENGER SEATBELT TENSION SENSOR-CIRCUIT VOLTAGE BELOW THRESHOLD |
| B0061-17 | PASSENGER SEATBELT TENSION SENSOR-CIRCUIT VOLTAGE ABOVE THRESHOLD |
| B0061-2A | PASSENGER SEATBELT TENSION SENSOR-STUCK |
| B1B9D-00 | PASSENGER BLADDER FLUID LEVEL LOW |
| B1BA8-00 | OCM SYSTEM OUT OF CALIBRATION/NOT CALIBRATED |
| B210A-00 | SYSTEM VOLTAGE LOW |
| B210B-00 | SYSTEM VOLTAGE HIGH |
| B2201-00 | OCCUPANT CLASSIFICATION MODULE INTERNAL |
| B222A-00 | VEHICLE LINE MISMATCH |
| U0002-00 | CAN C BUS OFF PERFORMANCE |
| U0140-00 | LOST COMMUNICATION WITH BCM |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.