Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Dodge and Ram Viper BaseFACTORY OEM SERVICE PROCEDURE
Torque Specifications
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | NEW FASTENER* |
|---|---|---|---|---|
| Driver Airbag Mounting Screws | 13 | 10 | - | |
| Passenger Airbag Mounting Screws | 9 | - | 80 | |
| Side Airbag Inflator Bracket Mounting Screws | 10 | 7 | - | |
| Side Airbag Manifold Bracket Mounting Screw | 10 | 7 | - | |
| Side Airbag Deploy Bracket Mounting Screws | 10 | 7 | - | |
| Door Trim Panel Tether Bracket Mounting Screw | 9 | - | 80 | |
| Child Tether Anchor Plate Mounting Screw | 20 | 15 | - | |
| Seat Belt Buckle Mounting Screw | 40 | 30 | - | |
| Clockspring Mounting Screws | 3 | - | 25 | |
| Occupant Restraint Controller Mounting Nuts | 10 | 7 | - | |
| Seat Belt Retractor Mounting Screws | 50 | 37 | - | |
| Seat Belt Lower Anchor or Belt Tension Sensor Mounting Screw | 50 | 37 | - | |
| Front Impact Sensor Mounting Screw | 7 | - | 62 | |
| Side B-Pillar Impact Sensor Mounting Nut | 9 | - | 80 | |
| Side Door Impact Sensor Mounting Screws | 3.6 | - | 32 | |
| Seat Track Position Sensor Mounting Screw | 2 | - | 15 | |
| Seat Belt Turning Loop Mounting Screws | 20 | 15 | - | |
| *NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. | ||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.