Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Dodge and Ram Viper BaseFACTORY OEM SERVICE PROCEDURE
Diagnostic Test
Replace the Occupant Classification Module (OCM)
- Make sure the battery is fully charged.
- Turn the ignition off, wait ten seconds and turn ignition on.
- With the scan tool, read the OCM DTC.
Did the scan tool display active or stored B2212-00-OCCUPANT CLASSIFICATION MODULE INTERNAL DTC?
Yes
- Replace the OCCUPANT CLASSIFICATION MODULE (OCM). Refer to MODULE, OCCUPANT CLASSIFICATION, REMOVAL .
- Perform the OCCUPANT CLASSIFICATION MODULE (OCM) VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Perform the OCCUPANT CLASSIFICATION MODULE (OCM) VERIFICATION TEST. Refer to STANDARD PROCEDURE .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.