Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Dodge and Ram C/VFACTORY OEM SERVICE PROCEDURE
Torque Specifications
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| Bolt, Accessory Drive Belt Tensioner Assembly | |||
| (3.6L) | 55 | 41 | - |
| Idler Pulley 3.6L | 25 | 18 | - |
| Bolt, Generator AND A/C Compressor Drive Belt Tensioner Assembly (2.8L Diesel) | 55 | 41 | - |
| Engine Coolant Temperature Sensor | 11 | 8 | - |
| Bolts, Coolant Outlet Connector/Thermostat Housing | |||
| (3.6L) | 12 | 9 | - |
| (2.8L Diesel) | 28 | 21 | - |
| Bolts, Water Pump | |||
| (3.6L) | 12 | 9 | - |
| (2.8L Diesel) | 32 | 24 | - |
| Bolts, Water Pump Inlet Tube (2.8L) | 12 | 9 | - |
| Bolts, Water Pump Inlet Tube (3.6L) | 12 | 9 | - |
| Screws, Radiator to A/C Condenser | 5 | - | 45 |
| Screws, Radiator Fan | 5 | - | 45 |
| Nuts, Radiator Mounting (Upper Bracket) | 12 | 9 | 106 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
