Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Dodge and Ram Nitro Detonator, 4WDFACTORY OEM SERVICE PROCEDURE
Transmission Control Module: Remove & Replace
WARNING: This page is about the Nitro Heat, 3.7 K, 4WD, which is a different variant/trim than selected.
4 AND 5 SPEED TRANS, TRANS ID - A500, A518, AW372, KM148, MR600, R4AC1, V4AC1,42RE, 42RLE, 42RH, 44RE, 45RFE, 46RE, 46RH, 47RE, 47RH, 48RE, 545RFE
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Includes: Programming. | 1.5 | B |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.