2010 Dodge and Ram Caliber ExpressFACTORY OEM SERVICE PROCEDURE

Diagnostic Test

  1. CHECK FOR CAN BUS DTCS 
    1. With the scan tool, check for CAN BUS DTCs.

      Are there any CAN BUS DTCs present?

      Yes 

      No 

      • Go to step  2
  2. CHECK IF CONTROLLER WAS REPLACED 

    Has the Transmission Control Module been recently replaced?

    Yes 

    • Go to step  3

    No 

    • Go to step  5
  3. CHECK IF CONTROLLER WAS PROGRAMED 

    Was the Transmission Control Module flashed?

    Yes 

    • Go to step  4

    No 

  4. CHECK FOR OTHER DTCS 
    1. With the scan tool, check Transmission DTCs.

      Are the DTCs P0602 and U140F Active and P161B and P1729 Stored?

      Yes 

      No 

      • Go to step  5
  5. CHECK THE TIPM FOR PROPER PROGRAMING OF TIRE SIZE 
    1. With the scan tool, check the TIPM for proper tire size programing.

      Is the tire size properly programed in the TIPM?

      Yes 

      • Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. Check for any Service Bulletins for possible causes that may apply. If no problems are found, replace the TCM in accordance with the Service Information.
      • Perform the CVT VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure .

      No 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.