Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Dodge and Ram Magnum BaseFACTORY OEM SERVICE PROCEDURE
Speed Control DTCS
SPEED CONTROL DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| C124B | XBW RULE VIOLATION |
| C124C | ACC DISABLED DUE TO ESP |
| C160A | ECU OVERTEMPERATURE |
| C2206 | VEHICLE CONFIGURATION MISMATCH |
| C2315 | ACC DISABLED DUE TO PCM FAULT |
| P0562 | BATTERY VOLTAGE LOW |
| P0563 | BATTERY VOLTAGE HIGH |
| P1519 | CRUISE CONTROL FRONT DISTANCE SENSOR LENS CRACKED MISSING |
| P1614 | ECU RESET/RECOVERY OCCURRED |
| P161A | ECU IN-PLANT MODE ACTIVE |
| P1644 | INCORRECT VARIANT/CONFIGURATION |
| P1666 | CRUISE CONTROL MODULE INTERNAL |
| P1678 | ECU SENSOR ADJUSTMENT REQUIRED |
| U0001 | CAN C BUS OFF PERFORMANCE |
| U0100 | LOST COMMUNICATION WITH ECM/PCM |
| U0101 | LOST COMMUNICATION WITH TCM |
| U0121 | LOST COMMUNICATION WITH ANTI-LOCK BRAKE MODULE |
| U0141 | LOST COMMUNICATION WITH FRONT CONTROL MODULE |
| U0401 | IMPLAUSIBLE DATA RECEIVED FROM ECM/PCM |
| U0402 | IMPLAUSIBLE DATA RECEIVED FROM TCM |
| U0415 | IMPLAUSIBLE DATA RECEIVED FROM ABS |
| U0429 | IMPLAUSIBLE DATA RECEIVED FROM SCM |
| U0431 | IMPLAUSIBLE DATA RECEIVED FROM FCM |
| U110A | LOST COMMUNICATION WITH SCCM - CAN C |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
