Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Dodge and Ram Charger SEFACTORY OEM SERVICE PROCEDURE
Module-Steering Column Control: Installation
- Install the SCCM (1) onto the steering column.
- Tighten the set screw (1) securing the SCCM (2).
- Tighten clockspring screw(s) (1) that were backed out to keep the clockspring from unwinding.
- Align the spline on the steering wheel hub to shaft and install the steering wheel (1).
- Install a NEW retaining bolt (2). Torque the bolt to 70 N.m (52 ft. lbs.).
- Install the driver airbag (3) (Refer to ELECTRICAL/RESTRAINTS/DRIVER AIRBAG - INSTALLATION) .
- Connect the battery negative cable. If equipped with Electronic Stability Program (ESP), the steering angle sensor must be calibrated (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE) .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.