Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Dodge and Ram Neon SE, StandardFACTORY OEM SERVICE PROCEDURE
Side Impact Airbag Control Module: Removal
The removal and installation of the driver and passenger side modules is identical. The orientation of the modules is the only difference.
WARNING:
THE MODULES CANNOT BE INTERCHANGED. THEY ARE UNIQUE TO EACH SIDE. FAILURE TO INSTALL THEM PROPERLY COULD RESULT IN OCCUPANT PERSONAL INJURY OR DEATH.
- Open hood.
- Disconnect and isolate the battery negative cable. See Figure.
- Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
- Remove the door sill trim from the appropriate side of the vehicle (Refer to BODY/INTERIOR/DOOR SILL TRIM - REMOVAL) .
- Peel back carpet to gain access to the retaining screws.
- Remove the SIACM retaining screws. See Figure.
- Disconnect the SIACM electrical connector. See Figure.
- Remove the SIACM from the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.