Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Dodge and Ram Neon SE, StandardFACTORY OEM SERVICE PROCEDURE
Restraints Control Systems: CLOCKSPRING: Installation
- When reusing the clock spring, Locate the clock spring on the steering shaft and push down on the rotor until the clock spring is fully seated on the steering column. Refer to STANDARD PROCEDURE - CLOCK SPRING CENTERING .
- When installing a new clock spring, position the front wheels straight a head. Remove locking pi. Refer to STANDARD PROCEDURE - CLOCK SPRING CENTERING .
- Connect the clock spring to the instrument panel harness, ensure wiring is properly routed. Then check that the connectors and locking tabs are properly engaged.
- Install the multi-function switch (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/MULTI-FUNCTION SWITCH - INSTALLATION) .
- Install steering column shrouds. Be sure all wires are inside of shrouds (Refer to STEERING/COLUMN/UPPER SHROUD - INSTALLATION) .
- Install steering wheel ensuring the flats on hub align with the clock spring. Feed the horn, airbag and speed control wires through the bottom slot. Ensure wires do not get pinched under the steering wheel.
- Connect the speed control wire to the switch.
- Connect the horn connector and the airbag squib connector to the driver airbag.
- Install steering wheel (Refer to STEERING/COLUMN/STEERING WHEEL - INSTALLATION) .
- Install the driver airbag and tighten bolts to 12 to 14 N.m (105 to 125 in. lbs.) torque.
WARNING:
DO NOT CONNECT THE BATTERY NEGATIVE CABLE. REFER TO DIAGNOSIS AND TESTING - AIRBAG SYSTEM FIRST. FAILURE TO DO SO COULD RESULT IN OCCUPANT PERSONAL INJURY OR DEATH.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.