Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Dodge and Ram Neon SE, StandardFACTORY OEM SERVICE PROCEDURE
Restraints Control Systems: CLOCKSPRING: Description
| 1 - LOCKING PIN |
| 2 - DRIVER AIRBAG WIRE/CONNECTOR |
| 3 - HORN WIRE/CONNECTOR |
| 4 - SPEED CONTROL WIRE/CONNECTOR |
The clock spring is mounted to the steering column behind the steering wheel. See Fig 1. The clock spring is used to maintain a continuous electrical circuit between the wiring harness and the:
- Driver Airbag.
- Speed Control Switch.
- Horn Switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.