Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Dodge and Ram Neon SE, StandardFACTORY OEM SERVICE PROCEDURE
Airbag Control Module: Installation
- Connect ACM connector and ensure that the connector and all locking tabs are engaged.CAUTION: USE SUPPLIED NUTS ONLY.
- Position ACM (arrow pointing forward) in the console floor bracket, attach the nuts and tighten to 9.6 to 14 N.m (85 to 125 in. lbs.) torque.
- Install center console assembly. Refer to FLOOR CONSOLE .
WARNING:
DO NOT CONNECT THE BATTERY NEGATIVE CABLE. REFER TO DIAGNOSIS AND TESTING - AIRBAG SYSTEM
FIRST. FAILURE TO DO SO COULD RESULT IN OCCUPANT PERSONAL INJURY OR DEATH.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.