Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Dodge and Ram Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Mileage/Distance Functions
NOTE:
After making any repairs, perform BODY CONTROL MODULES SYSTEM VERIFICATION TEST
under VERIFICATION TESTS.
- Turn ignition on. Check other overhead console functions. If other overhead console functions are operating properly, go to next step. If other overhead console functions are not operating properly, replace overhead console.
- Turn ignition off. Connect scan tool to Data Link Connector (DLC). Turn ignition on. Using scan tool, retrieve Powertrain Control Module (PCM) DTCs. If any PCM DTCs exist, see appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE. If no PCM DTCs exist, go to next step.
- Ensure injector pulse, pinion factor, fuel fill procedure, brake adjustment and tire size are correct. Repair as necessary. If no problems are found, check if any Technical Service Bulletins (TSBs) apply to vehicle. If no TSBs apply, test is complete.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.