Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Dodge and Ram Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Powertrain Control Module: Notes
NOTE:
If Powertrain Control Module (PCM) has been replaced, the correct vehicle mileage and Vehicle Identification Number (VIN) must be programmed into replacement PCM to prevent DTCs from being set in Anti-Lock Brake System (ABS) Controller Anti-Lock Brake (CAB) and Occupant Restraint Controller (ORC). If replacing Powertrain Control Module (PCM) on models equipped with a Sentry Key Immobilizer Module (SKIM), "Secret Key" data must also be updated to enable engine starting. See SENTRY KEY IMMOBILIZER Module under PROGRAMMING in
BODY CONTROL MODULES - CONCORDE, INTREPID, LHS & 300M article.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.