Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Dodge and Ram Neon High Line, AutomaticFACTORY OEM SERVICE PROCEDURE
Removal & Installation
WARNING: This page is about the Neon Base, Automatic, which is a different variant/trim than selected.
3 SPEED TRANS
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Trans Mfr CD 31TH | 3.8 | C | ||
| Combination Procedure: CLUTCH SEALS: Remove & Replace: | ||||
| Trans Mfr CD 31TH, Front or Rear | 1.1 | 1.1 | A | |
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| Trans Mfr CD 31TH | 0.5 | 0.3 | C | |
| Combination Procedure: KICKDOWN BAND: Remove & Replace: | ||||
| Trans Mfr CD 31TH | 0.9 | 0.9 | A | |
| Combination Procedure: OIL PUMP: Remove & Replace: | ||||
| Trans Mfr CD 31TH, Front | 0.6 | 0.6 | B | |
| Combination Procedure: REACTION SHAFT: Remove & Replace: | ||||
| Trans Mfr CD 31TH | 0.6 | 0.6 | A | |
| Combination Procedure: REVERSE BAND: Remove & Replace: | ||||
| Trans Mfr CD 31TH | 1.1 | 1.1 | A | |
| Combination Procedure: SPEEDOMETER DRIVE GEAR: Remove & Replace: | ||||
| Trans Mfr CD 31TH | 1.5 | B | ||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| Trans Mfr CD 31TH | 0.2 | 0.2 | C | |
| Combination Procedure: TRANSAXLE ASSEMBLY: Replace: | ||||
| Trans Mfr CD 31TH | 0.6 | 0.4 | C | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.