Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2000INTREPID R/TREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - SELF-DIAGNOSTICSDIAGNOSTIC TESTSDTC P0153: 2/1 O2 SENSOR SLOW RESPONSENOTES
2000 Dodge and Ram Intrepid R/T
DTC P0153: 2/1 O2 Sensor Slow Response: Notes
2000 Dodge and Ram Intrepid R/TSECTION Notes
NOTE:
For circuit identification, see WIRING DIAGRAMS article. If replacing Powertrain Control Module (PCM), PCM must be reprogrammed. See PROGRAMMING . After each repair procedure has been completed, reconnect all components. Perform TEST VER-5 to ensure system is functioning properly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.