Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Dodge and Ram Intrepid R/TFACTORY OEM SERVICE PROCEDURE
Front Riser Down Position Stuck
- Disconnect power seat switch harness connector. Turn ignition on. Measure voltage at terminal No. 6 (Red/Light Green wire) at power seat switch harness connector. See Fig 1 . If any voltage exists, go to next step. If no voltage exists, replace power seat switch.
- Disconnect Memory Heated Seat/Mirror Module (MHSMM) harness connector C1. Measure voltage at terminal No. 8 (Red/Light Green wire) at MHSMM harness connector C1. See Figure . If no voltage exists, replace MHSMM. If any voltage exists, repair short to voltage in Red/Light Green wire between power seat switch and MHSMM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.