Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2000INTREPID R/TREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEBODY, CAB CONTROL SYSTEMSBODY CONTROL MODULESREMOVAL & INSTALLATIONTRANSMISSION CONTROL MODULEREMOVAL & INSTALLATION
2000 Dodge and Ram Intrepid R/T
Removal & Installation
2000 Dodge and Ram Intrepid R/TSECTION Removal & Installation
- Transmission Control Module (TCM) is located at driver's side front corner of engine compartment, next to power distribution center and Powertrain Control Module (PCM). See Figure .
- Disconnect negative battery cable at remote battery terminal on passenger's side strut tower. Remove speed control servo with bracket and lay aside.
- Remove filler neck from windshield washer fluid bottle. Disconnect harness connectors from TCM. Remove TCM. To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.