2000 Dodge and Ram Intrepid R/TFACTORY OEM SERVICE PROCEDURE

Component Locations

NOTE: For component locations, see Fig 1 - Fig 4 .
COMPONENT LOCATIONS

Component Location
Ambient Temperature Sensor In Front Of Radiator
Body Control Module (BCM) On Back Of Junction Block
Controller Anti-Lock Brake (CAB) Next To Washer Reservoir
Data Link Connector (DLC) Under Left Side Of Instrument Panel
Decklid Release Switch Left Side Of Instrument Panel
Door Lock Switch On Appropriate Door Panel
Headlight Switch Left Side Of Instrument Panel
Heated Seat Back Heater Under Seat Cover
Heated Seat Cushion Heater Under Seat Cover
Heated Seat Switch Side Of Seat
Ignition Switch On Steering Column
Junction Block Behind Left Side Of Instrument Panel
Left Body Harness Connector C308 Under Right Side Of Rear Seat
Memory Heated Seat/Mirror Module (MHSMM) Under Driver's Seat
Memory Set Switch On Side Of Drive's Seat
Occupant Restraint Controller (ORC) Behind Center Of Instrument Panel
Overhead Travel Information System (OTIS) Module Front Center Of Headliner
Power Distribution Center Left Side Of Engine Compartment
Power Seat Switch Side Of Seat
Powertrain Control Module (PCM) Left Side Of Engine Compartment
Rear Window Defogger Relay Right Side Of Trunk
Remote Keyless Entry Module On Back Of Junction Block
Seat Motor Sensors On Seat Motors, Under Seat
Sentry Key Immobilizer Module (SKIM) On Steering Column
Speed Proportional Steering Solenoid Under Brake Master Cylinder
Sun Sensor/VTSS Indicator Top Center Of Instrument Panel
Transmission Control Module (TCM) Left Side Of Engine Compartment
Traction Control Switch Left Center Of Instrument Panel
Turn Signal/Hazard Switch On Steering Column
Washer Fluid Level Switch Left Front Corner Of Engine Compartment
Washer Pump Left Front Corner Of Engine Compartment
Washer Reservoir Left Front Corner Of Engine Compartment
Wiper/Washer Switch Part Of Multifunction Switch
Fig 1: Locating Components
G99C54140Courtesy of DAIMLERCHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.