Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Dodge and Ram Viper GTS-RFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | N.m (Ft. Lbs.) | |
|---|---|---|
| Adapter Bolts | 34 (25) | |
| Clutch Cover Bolts | 30 (22) | |
| Clutch Release Bearing | 20 (15) | |
| Drain Plug | 38 (28) | |
| Fill Plug | 27 (20) | |
| Flywheel Bolts | 74 (55) | |
| Guide Plate Bolts | 22 (16) | |
| Trans. Crossmember Bolts | 81 (60) | |
| Trans. Mount Bolts | 41 (30) | |
| Trans.-To-Engine Bolts | ||
| 3/8" Diameter | 41 (30) | |
| 7/16" Diameter | 68 (50) | |
| N.m (INCH Lbs.) | ||
| Clutch Bleed Bolt | 18 (156) | |
| Clutch Release Bearing | 20 (200) | |
| U-Joint Clamp Bolts | 19 (170) | |
| Speed Sensor Bolt | 11 (95) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.