Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Dodge and Ram Viper GTS-RFACTORY OEM SERVICE PROCEDURE
Toe Pattern Preparation
Before toe pattern can be inspected, vehicle design height, suspension settings and design bushing position must be checked. Ensure the following:
- Verify that all fluid reservoirs and fuel tank are full.
- Position vehicle on a known level surface (suspension or frame alignment rack).
- Remove all objects from vehicle that were not installed at assembly plant.
- Inflate tires to specification found on tire inflation sticker on left door end frame.
- Disconnect front and rear stabilizer bar links from lower control arms.
- Verify vehicle design height, caster, camber and toe settings are within specifications.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.