1998 Dodge and Ram Viper GTS-RFACTORY OEM SERVICE PROCEDURE

Clock Spring: Installation

  1. When installing, snap clock spring onto steering column. Ensure that clock spring is in proper positioned before installing. Connect clock spring wiring to instrument panel wire harness. Be certain that wiring locator clips are properly seated on outside of wiring trough and that locking tabs are engaged. Install steering column shrouds. Be certain that airbag wire is inside shrouds.
  2. The front wheels should still be in straightahead position. Install steering wheel being certain to fit flats on hub of steering wheel with formations on inside of clock spring. Pull wiring through upper and lower holes in steering wheel hub. Tighten steering wheel nut to 61 N.m (45 ft. lbs.) torque.
  3. Be certain not to pinch wiring between steering wheel and nut. Connect horn switch wire, then airbag wire to driver airbag. Install driver airbag and tighten screws to 10.2 N.m (90 INCH lbs.) torque.
WARNING: DO NOT connect negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.