1998 Dodge and Ram Viper GTS-RFACTORY OEM SERVICE PROCEDURE

Non-Scan Tool Method

  1. To enter programming mode, disarm entry module. Ground pin C13 of entry module J3 connector (6 inch Green pigtail wire located at entry module).
  2. Turn ignition switch to RUN position. Receiver acknowledges programming mode by flashing Vehicle Theft Security System LED located on top, center of instrument panel. See Fig 1 .
    NOTE: Program mode will time out if no valid transmitter code is received within 60 seconds. The timer resets after each successful transmitter programming.
  3. Send transmitter code by pressing either button on transmitter for approximately 10 seconds. A successful programming will be acknowledged with a horn chirp. Repeat for both transmitters. All transmitters MUST be reprogrammed anytime a new fob is added.
Fig 1: Vehicle Theft Security System LED
G00058330Courtesy of DAIMLERCHRYSLER CORPORATION
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.