Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Dodge and Ram Rampage Base, Automatic TransFACTORY OEM SERVICE PROCEDURE
Removal & Installation
- Remove battery. Disconnect 10-wire and 6-wire connectors from computer. Remove outside air duct from computer. Disconnect vacuum hose from vacuum transducer.
- Remove 3 mounting screws that hold computer to fenderwell and remove computer. To install, reverse removal procedure.NOTE: Computer is not serviceable. Do not attempt to take it apart for any reason. Also, if the vacuum transducer becomes defective, entire computer must be replaced.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.