2000 Daewoo Leganza CDXFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Battery Cable Nuts 11 (15)
Battery Carrier Tray Upper Bolts 15 (20)
Battery Terminal Bolts 15 (20)
Battery-To-Generator Lead Nut 11 (15)
Generator Driveshaft Nut 74 (100)
Generator Lower Bracket-To-Engine Block Bolts 22 (30)
Generator Lower Bracket-To-Generator Nut 15 (20)
Generator Through-Bolts 18 (25)
Generator-To-Cylinder Head Support Bracket Bolt 15 (20)
Generator-To-Intake Manifold And Cylinder Head Support Bracket Bolts 26 (35)
Generator-To-Intake Maifold Strap Bracket Bolt 15 (20)
Starter-To-Engine Block Mounting Bolt 33 (45)
Starter-To-Transmission Mounting Bolt 37 (50)
INCH Lbs. (N.m)Β 
Battery Cable Tray Lower Bolts 89 (10)
Battery Retainer Clamp-To-Battery Rod Nuts 35 (4)
Starter Field Connector Nut 71 (8)
Starter Solenoid Assembly Screws 71 (8)
Starter Solenoid Terminal-To-Battery Cable Terminal Nut 62 (7)
Starter Solenoid Terminal-To-Ignition Solenoid Terminal Nut 53 (6)
Starter Through-Bolt 53 (6)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.