Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2023 Chrysler 300 CFACTORY OEM SERVICE PROCEDURE

Sensor, Camshaft Position: Description: Notes

Courtesy of CHRYSLER GROUP, LLC

The Camshaft Position (CMP) sensor (2) is mounted on the left upper timing cover. The Hall effect sensor supplies a signal to the Powertrain Control Module (PCM). The PCM uses the signals sent by the CMP and the Crankshaft Position (CKP) sensor to determine ignition and injection timing.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.