Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Chrysler Voyager L, GasFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Passenger Airbag Mounting Screws | 9 | - | 80 | |
| Side Airbag Inflatable Curtain Mounting Nuts | 6 | - | 53 | |
| Driver or Passenger Knee AirBag Mounting Screws | 8 | - | 71 | |
| Front Seat Belt Buckle Mounting Bolts | 40 | 30 | - | |
| 2nd Row Seat Belt Buckle Mounting Bolts | 55 | 41 | - | |
| 2nd Row Bench Seat Belt Buckle Mounting Bolts | 65 | 48 | - | |
| 3rd Row Seat Belt Buckle Mounting Bolts and Nuts | 50 | 37 | - | |
| Front Seat Belt Anchor Tensioner/Retractor Mounting Screw | 39 | 29 | - | |
| Height Adjuster Screw To Pillar | 40 | 35 | - | |
| 1st and 2nd Row Seat Belt Turning Loop To Height Adjuster Nut | 39 | 29 | - | |
| 3rd Row Seat Belt Turning Loop To Pillar Mounting Screw | 40 | 35 | - | |
| Occupant Restraint Controller Mounting Nuts | 9 | - | 80 | |
| 2nd and 3rd Row Outboard Seat Belt Retractor to Pillar Mounting Screws | 39 | 29 | - | |
| 2nd and 3rd Row Outboard Seat Belt Lower Anchor To Body Mounting Screws | 39 | 29 | - | |
| Seat Belt Upper Anchor (D-Ring) To Body Mounting Screws | 48 | 35 | - | |
| 2nd and 3rd Row Center Seat Belt Roof Mounted Retractor Nuts | 45 | 33 | - | |
| 2nd and 3rd Row Center Seat Belt Roof Anchor Mounting Screw | 40 | 30 | - | |
| Front Impact Sensor Screw | 11 | - | 98 | |
| Side Impact Sensor To C or D-Pillar Mounting Nuts | 11 | - | 98 | |
| Side Impact Sensor To B-Pillar Mounting Nuts | 11 | - | 98 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.