Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Chrysler 300 CFACTORY OEM SERVICE PROCEDURE
Solenoid, Variable Valve Timing: Removal: Left
- Disconnect and isolate the negative battery cable.
- Remove the engine cover (1).
- Remove the air cleaner body. Refer to REMOVAL
.NOTE:
Mark the Variable Valve Timing Solenoid (VVTS) wire harness connectors (1) with a paint pen or equivalent so that they may be reinstalled in their original locations.
- Mark the intake VVTS (4) and the VVTS (2) with a paint pen or equivalent so that they may be reinstalled in their original locations.
- Disconnect the VVTS wire harness connector (1).
- Remove the bolts (3) and pull the VVTS from the cylinder head cover.
- The seal (1) can be reused if not damaged.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
