Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Auxiliary Fuel Pump Module
The Main Fuel Pump Module must be removed for Auxiliary Fuel Pump Module removal.
- Remove the main fuel pump module, see. Refer to MAIN FUEL PUMP MODULEΒ .
- Remove the auxiliary fuel pump module plastic access cover (1) from the floor pan.NOTE:
Prior to removing the fuel pump module, use compressed air to remove any accumulated dirt and debris from around fuel tank opening.
- Disconnect the fuel supply line (2) from the auxiliary fuel pump module (1).
- Mark the auxiliary fuel pump module orientation.
- Position the SAE Fuel Pump Lock Ring Wrench (special tool #9340, SAE Fuel Pump Lock Ring Wrench) (1) into the notches on the outside edge of the lock ring (2).
- Install a 1/2 inch drive breaker bar into the SAE Fuel Pump Lock Ring Wrench (special tool #9340, SAE Fuel Pump Lock Ring Wrench) (1).
- Rotate the breaker bar counterclockwise and remove the lock ring (2).CAUTION:
Do not allow the float arm of the auxiliary fuel pump module to come in contact with any part of the fuel tank during removal or installation, damage to the float arm and fuel level sending card may result.
- Lift the auxiliary fuel pump module up and out of fuel tank while guiding the fuel supply and return lines out from the left side of the fuel tank.NOTE:
Whenever a fuel pump module is serviced, the rubber O-ring seal must be replaced.
- Remove and discard the rubber O-ring seal.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
