Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Chrysler 300 CFACTORY OEM SERVICE PROCEDURE
External Pages
These are pages that do not belong to the exact selected vehicle (2019 Chrysler 300 C), but are still accessible from a link in your vehicle's manual. Be very cautious using repair info from here because these pages may not apply to your vehicle.
- Different variant/trim
- Section 1 (3.6L - DTCS P0138 To P0345)
- Section 2 (3.6L Engine (Service Information))
- Section 3 (8HP50/850RE Automatic Transmission (Service Information))
- Section 4 (8HP50/850RE Automatic Transmission - Diagnostic Code Index)
- Section 5 (8HP50/850RE Automatic Transmission - DTCS P0219-00 To P1D93-00)
- Section 6 (8HP50/850RE Automatic Transmission - DTCS P1D94-00 To U1479-00)
- Section 7 (3.6L - Intermittent Condition, Powertrain Verification Test & Pre-Diagnostic Troubleshooting Procedure)
- Section 8 (3.6L - DTCS P0349 To P060E)
- Section 9 (8HP50/850RE Automatic Transmission - Pre-Diagnostic Troubleshooting Procedure, Transmission Verification Test & TCM Adaptation)
- Section 10 (3.6L - DTCS C053D To P0137)
- Section 11 (3.6L - DTCS P060F To P1E0A)
- Section 12 (3.6L - DTCS P2066 To P258B)
- Section 13 (3.6L - DTCS P2610 To U1431)
- Section 14 (BW44-40 Transfer Case (Service Information))
- Section 15 ((Electronic Shift Module (ESM) - Electrical Diagnostics - 8HP50/850RE Automatic Transmission))
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.