2011 Chrysler 300 V8-5.7LFACTORY OEM SERVICE PROCEDURE

Adaptive Front Lighting System Module - Removal





REMOVAL

Factory service manual diagram




1. Disconnect and isolate the battery negative cable.
2. Locate the Adaptive Front Lighting System (AFLS) module (1) at the right front corner of the Power Distribution Center (PDC) in the right front corner of the engine compartment.
3. Release the AFLS module latch tab by pressing it toward the PDC.
4. While holding the AFLS module latch tab in the released position, pull the module upward to disengage it from the blade-type mount (2) integral to the right front corner of the PDC bracket.
5. Disconnect the headlamp and dash wire harness connector (3) from the AFLS module connector receptacle.
6. Remove the AFLS module from the vehicle.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.