INSTALLATION

1. If the humidity sensor bracket (1) is damaged and cannot be reused, install a new windshield Windshield - Installation.
2. Connect the wire harness connector (1) to the humidity sensor (4).

CAUTION: Use care when installing the humidity sensor. The humidity sensor bracket cannot be serviced separately from the windshield. If the sensor bracket becomes damaged, the windshield will need to be replaced.

3. Position the humidity sensor to the sensor bracket (2) and engage the metal retaining clip (3) to the bracket. Make sure both sides of the retaining clip are fully engaged to the bracket.

CAUTION: Use care when install the humidity sensor cover. The humidity sensor bracket cannot be serviced separately from the windshield. If the sensor bracket becomes damaged, the windshield will need to be replaced.

4. Carefully install the humidity sensor cover (3) onto the sensor bracket (1). Make sure the four retaining tabs (2 and 4) are fully engaged to the bracket
5. Reconnect the negative battery cable.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Humidity Sensor - Installation

Use the Manual With the Right Hardware

When to See a Mechanic