2011 Chrysler 300 V8-5.7LFACTORY OEM SERVICE PROCEDURE

Bracket





BRACKET

Factory service manual diagram





NOTE: The molded plastic ball socket clips in the ACC sensor mounting bracket MUST be removed, discarded and replaced with new ball socket clips any time the sensor is removed from the bracket.

1. Check to be certain that the two rivet nuts (4) are properly installed and in good condition in the front bumper support bar (5).
2. Install three new molded plastic ball socket clips into the adaptive speed control (also known as Adaptive Cruise Control/ACC) sensor mounting bracket (3). The clips are installed from the back side of the bracket by rotating them clockwise.
3. Position the mounting bracket to the bumper support bar.
4. Engage the retainer that secures the Front End Module (FEM) wire harness (6) to the back of the bracket.
5. Starting with the outboard (round) mounting hole followed by the inboard (slotted) mounting hole, install and tighten the two screws (2) that secure the mounting bracket to the support bar. Tighten the screws securely.
6. Reinstall the ACC sensor onto the mounting bracket. Sensor.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.