Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chrysler 300 V6-3.6LFACTORY OEM SERVICE PROCEDURE
Adaptive Front Lighting System Module - Installation
INSTALLATION
1. Position the Adaptive Front Lighting System (AFLS) module (1) into the right front corner of the engine compartment.
2. Reconnect the headlamp and dash wire harness connector (3) to the AFLS module connector receptacle.
3. Align the AFLS module mount to the blade-type bracket (2) integral to the right front corner of the Power Distribution Center (PDC) bracket.
4. Push the AFLS module mount down over the bracket until the latch feature snaps into place.
5. Reconnect the battery negative cable.
NOTE: Whenever the Advanced Front Lighting System (AFLS) module is removed and reinstalled or replaced with a new unit, it is necessary for the AFLSM to be configured and calibrated to the vehicle using a calibration procedure. Follow the programming steps outlined in the diagnostic scan tool for the "AFLS Module Calibrate" routine under "Miscellaneous Functions" for the "AFLS Module" menu item as appropriate.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
