Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chrysler 300 V6-3.6LFACTORY OEM SERVICE PROCEDURE
A/C And Heater Control Module - Installation
INSTALLATION
NOTE: Illustration shown with instrument panel removed from view for clarity.
1. Position the A/C heater module (1) to the air inlet housing (4) and engage the module to the two front retaining screws (2).
2. Loosely install the screw (5) that secures the rear of the A/C heater module to the air inlet housing.
3. Tighten all the screws that secure the A/C heater module to the air inlet housing to 2 Nm (17 in. lbs.).
4. Connect the wire harness connector (3) to the A/C heater module.
5. Install the glove box trim panel and glove box Instrument Panel Glove Box Door - Installation.
6. Install the right side instrument panel silencer Silencer Panel - Installation.
7. Reconnect the negative battery cable.
8. Initiate the Actuator Calibration function using a scan tool .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.