Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chrysler 300 V6-3.6LFACTORY OEM SERVICE PROCEDURE
Body Control Module - Installation
INSTALLATION
1. Position the BCM in the vehicle.
2. Install the fasteners (4), two at the bottom, and one at the top, and tighten the securely.
3. Connect the electrical connectors to the Body Control Module (BCM) (1) receptacles (2 and 3) as needed.
4. Install the glove box assembly (1), Instrument Panel Glove Box Door - Removal.
5. Install the lower hush panel (3) and install the two push-pin type retainers.
6. Connect the negative battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.