Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chrysler 300 Base, GasFACTORY OEM SERVICE PROCEDURE
RADIATOR, Engine Cooling: Installation: 3.6L
- Position the radiator into engine compartment. Seat the radiator assembly lower rubber isolators into the mounting holes in radiator lower support.
- Install the radiator mounting bracket (1) and bolts (2). Tighten to 12 N.m (106 in. lbs.).
- Position the condenser on radiator and loosely install the support bolt.
- Install upper and lower mounting bolt. Tighten bolts to 10 N.m (88 in. lbs.).
- Tighten the support bolt to 10 N.m (88 in. lbs.).
- Install the air deflectors (1).
- Position the hood latch release cable (2) through the notch in deflector.
- Install the front bumper fascia. Refer to FASCIA, Front, Installation .
- Raise the vehicle.
1 - LOWER RADIATOR HOSE 2 - RADIATOR FAN ASSEMBLY - Install the lower radiator hose (1) and clamp.
- Install the lower engine cover.
- Lower vehicle.
1 - UPPER RADIATOR CLOSURE PANELS 2 - UPPER RADIATOR HOSE 3 - RADIATOR FAN ELECTRICAL CONNECTOR 4 - RADIATOR FAN ASSEMBLY - Install the radiator fan. Refer to FAN, Cooling, InstallationΒ .
- Install the upper radiator upper hose (2). Align hose so it does not interfere with the accessory drive belt or engine. Position hose clamp so it will not interfere with the hood.
- Connect the negative cable.
- Fill the cooling system with coolant. Refer to Standard ProcedureΒ .
- Operate the engine until it reaches normal operating temperature. Check the cooling system and automatic transmission for the correct fluid levels.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
