Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chrysler 300 Base, GasFACTORY OEM SERVICE PROCEDURE
Quick Lookups: Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Air Cond Compressor Oil | 6.10 OZS. | 0.18 L | PAG 46 | S | |||
| Air Cond Refrigerant | 1.56 LBS. | 0.7 KG | R-134a | S | |||
| Automatic Transmission Fluid | Overhaul | 8.10 QTS. | 7.66 L | Automatic Transmission Fluid Plus 4 or equivalent | Dry fill capacity. Depending on type and size of Internal Cooler, length and inside diameter of Cooler Lines, or use of an Auxiliary Cooler, these figures may vary. | S | |
| Automatic Transmission Fluid | Service Fill | 5.30 QTS. | 5.01 L | Automatic Transmission Fluid Plus 4 or equivalent | S | ||
| Brake Fluid | N/A | N/A | DOT 3 Brake Fluid, SAE J1703 | If MOPAR Brake Fluid DOT 3 is not available, then MOPAR Brake Fluid DOT 4, is acceptable. | S | ||
| Differential Gear Oil | 175mm FIA Front Axle | 0.63 QTS. | 0.59 L | MOPAR Synthetic Gear Oil, SAE 75W-90 | S | ||
| Differential Gear Oil | 198mm RII Rear Axle | 1.50 QTS. | 1.41 L | MOPAR Synthetic Gear Oil, SAE 75W-140 | S | ||
| Differential Gear Oil | 200mm RII Rear Axle | 1.20 QTS. | 1.13 L | MOPAR Synthetic Gear Oil, SAE 75W-140 | S | ||
| Differential Gear Oil | 215mm RII Rear Axle | 1.30 QTS. | 1.23 L | MOPAR Synthetic Gear Oil, SAE 75W-140 | S | ||
| Differential Gear Oil | 226mm RII Rear Axle | 1.30 QTS. | 1.23 L | MOPAR Synthetic Gear Oil, SAE 75W-90 | Limited-Slip Rear Axles require the addition of 118 ml (4 oz.) MOPAR Limited Slip Additive. | S | |
| Engine Coolant | 3.6L Eng | 10.40 QTS. | 9.84 L | MOPAR Antifreeze/Coolant 5 Year/100,000 Mile Formula HOAT (Hybrid Organic Additive Technology) or equivalent | Includes: heater and coolant recovery tank filled to "max" level. DO NOT mix different types or colors of engine coolant. | S | |
| Engine Oil | 3.6L Eng | w/Filter | 6.00 QTS. | 5.67 L | API - SAE 5W-30 | For countries that use the ACEA European Oil Categories for Service Fill Oils, use the recommended engine oil that meets the requirements of ACEA C3, and approved to MB 229.31 or MB 229.51 only. SAE 5W-30 engine oil approved to MB 229.31 or MB 229.51 may be used when SAE 5W-20 engine oil is not available | S |
| Fuel Tank | 3.6L Eng | 19.00 GALS. | 71.92 L | S | |||
| Power Steering Fluid | N/A | N/A | Hydraulic Power Steering Fluid | This vehicle features an Electro Hydraulic Power Steering (EHPS) pump which requires a different power steering fluid. Do not mix power steering fluid types. Damage may result to the power steering pump and system if any other fluid is used. The EHPS system uses fluid which meets material specification MS-11655 or equivalent | S | ||
| Transfer Case Fluid | 2.11 PTS. | 0.99 L | MOPAR Transfer Case Lubricant for Borg Warner 44-40 | S | |||
| Windshield Washer Fluid | N/A | N/A | Windshield Antifreeze | Not radiator antifreeze. Follow the Manufacturer's Instructions for the mixture ratio. | S | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.