Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chrysler 200 V6-3.6LFACTORY OEM SERVICE PROCEDURE
Intake Manifold
UPPER INTAKE MANIFOLD
The bolts must tightened in the sequence shown 7 Nm (62 in. lbs.)
Install the seven upper intake manifold attaching bolts.
Tighten the bolts 8 Nm (71 in. lbs.).
Install two nuts to the upper intake manifold support bracket
Tighten the nuts 10 Nm (89 in. lbs.)
Tighten the studbolt 20 Nm (177 in. lbs.)
Install two upper intake manifold support brackets with two studbolts and two nuts.
Tighten the studbolts 20 Nm (177 in. lbs.)
Tighten the nuts 10 Nm (89 in. lbs.)
LOWER INTAKE MANIFOLD
Install the fuel injectors and the fuel rail to the lower intake manifold.
Tighten the four bolts 7 Nm (62 in. lbs.)
Install the manifold attaching bolts 8 Nm (71 in. lbs.).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.